-- Exhibit – [image: https://examprepare.s3.amazonaws.com/F5_Networks/301b_Exam_LTM_Specialist_2025_89-0.png] -- Exhibit -- Refer to the exhibit. An LTM Specialist sets up AVR alerts and notifications for a specific virtual server if the server latency exceeds 50ms. The LTM Specialist simulates a fault so that the server latency is consistently exceeding the 50ms threshold; however, no alerts are being received. Which configuration should the LTM Specialist modify to achieve the expected results?
-- Exhibit – [image: https://examprepare.s3.amazonaws.com/F5_Networks/301b_Exam_LTM_Specialist_2025_90-0.png] -- Exhibit -- Refer to the exhibit. An LTM Specialist is troubleshooting an HTTP monitor that is marking a pool member as down. Connecting to the pool member directly through a browser shows the application is up and functioning correctly. ltm monitor http http_mon { defaults-from http destination *:* interval 5 recv "200 OK" send "GET /\\r\\n" time-until-up 0 timeout 16 } What is the issue?
-- Exhibit – -- Exhibit -- Refer to the exhibit. An LTM Specialist is troubleshooting an issue with SSL and is receiving the error shown when connecting to the virtual server. When connecting directly to the pool member, clients do NOT receive this message, and the application functions correctly. The LTM Specialist exports the appropriate certificate and key from the pool member and imports them into the LTM device. The LTM Specialist then creates the Client SSL profile and associates it with the virtual server. What is the issue?
-- Exhibit – -- Exhibit -- Refer to the exhibit. A user is unable to access a secure application via a virtual server. What is the cause of the issue?
-- Exhibit – -- Exhibit -- Refer to the exhibit. An LTM Specialist is troubleshooting an issue with a new virtual server. When connecting through the virtual server, clients receive the message "The connection was reset" in the browser. Connections directly to the pool member show the application is functioning correctly. What is the issue?
A OneConnect profile is applied to a virtual server. The LTM Specialist would like the client source IP addresses within the 10.10.10.0/25 range to reuse an existing server side connection. Which OneConnect profile source mask should the LTM Specialist use?
