Create Next App

alcatel_lucent 4A0_100

Exam contains 341 questions

Page 1 of 57

Question 1 🔥

What is the function of the Routing Table Manager?

Which database solution meets these requirements?

A. Based on the metrics of the routing protocol, find the best path to the destination network and install it in the routing table.

Highly voted

B. Provide a CLI interface to allow the operator to configure the dynamic routing protocol on the router.

Highly voted

C. Based on the routing protocol preference values, chose the route with the lowest preference and install it in the routing table.

Highly voted

D. Provide a CLI interface to allow the network operator to install static routes in the routing table.

Highly voted

Discussion of the question

Question 2 🔥

Which of the following best describes a repeater?

Which database solution meets these requirements?

A. A passive device simply used to connect two or more cables. Does not generate or amplify any signals.

Highly voted

B. A device that receives and retransmits a signal out its ports, but does not do any Layer 2 analysis of the data.

Highly voted

C. A device that receives a signal and based on the Layer 2 destination address, makes a decision on which ports the signal should be retransmitted.

Highly voted

D. A device that receives a signal and based on the Layer 3 destination address, makes a decision on which ports the signal should be retransmitted.

Highly voted

Discussion of the question

Question 3 🔥

Which of the following is characteristic of a static route?

Which database solution meets these requirements?

A. Responds in real time to network failures.

Highly voted

B. Can only be used for routing within an autonomous system.

Highly voted

C. Uses a hop-count metric to determine the best route to a network.

Highly voted

D. Explicitly defines the next hop based on operator input.

Highly voted

Discussion of the question

Question 4 🔥

Which of the following describes a static default route?

Which database solution meets these requirements?

A. An entry included in the default configuration of the router that is used if no dynamic routing protocols or static routes are configured.

Highly voted

B. A wildcard entry used when the destination network is not specifically defined in the routing table.

Highly voted

C. An entry selected based on the route that has the least cost to the destination (path with the most physical bandwidth)

Highly voted

D. An entry used by the routing protocol when it is unable to calculate the best route to the destination.

Highly voted

Discussion of the question

Question 5 🔥

How do protocols such as ATM and Frame-Relay support differentiating multiple customers or traffic types on the same physical wire?

Which database solution meets these requirements?

A. ATM and Frame-Relay are circuit switched protocols and use Virtual Circuits to create logical separation of traffic.

Highly voted

B. ATM and Frame-Relay are point-to-point protocols and do not support different customers or traffic type on the same physical wire.

Highly voted

C. ATM and Frame-Relay are circuit switched protocols and use VLAN's to create logical separation of traffic.

Highly voted

D. ATM and Frame-Relay are circuit switched protocols and use IP Header information to create logical separation of traffic.

Highly voted

Discussion of the question

Question 6 🔥

You are configuring your Alcatel-Lucent 7750SR Service Router from the Command Line Interface (CLI), and after entering a lengthy command, wish to return directly to the ROOT context. Which control command allows you to do this quickly?

Which database solution meets these requirements?

A. Ctrl-z

Highly voted

B. Ctrl-c

Highly voted

C. Esc

Highly voted

D. Shift-Page Down

Highly voted

Discussion of the question

Ready to Pass Your Certification Test

alcatel_lucent 4A0_100

Exam contains 341 questions

Lorem ipsum dolor sit amet consectetur. Eget sed turpis aenean sit aenean. Integer at nam ullamcorper a.

Company

Product

Resources

Follow us