A customer is trying to boot an operating system installed on a Cisco UCS B-Series blade server after a RAID1 cluster migration. The RAID LUN remains in inactive state during and after the service profile association and the server does not boot. What is the cause of this problem?
A customer would like to create an Ethernet traffic monitoring session on a Cisco UCS server to troubleshoot network connectivity. The customer has entered the following commands via CLI:UCS-A# scope eth-traffic-mon -UCS-A /eth-traffic-mon # scope fabric aUCS-A /eth-traffic-mon/fabric # create eth-mon-session EthMonitor33UCS-A /eth-traffic-mon/fabric/eth-mon-session* # create dest-interface 2 12UCS-A /eth-traffic-mon/fabric/eth-mon-session/dest-interface* # set speed 20gbpsUCS-A /eth-traffic-mon/fabric/eth-mon-session/dest-interface* # commit-bufferUCS-A /eth-traffic-mon/fabric/eth-mon-session/dest-interface #Which outcome will this command sequence produce?
A customer is configuring VSANs in a Cisco UCS domain. After configuring the VSANs 3840, 3841, and 3842 in FC end-host mode, the customer sees that theseVSANs are not operational and that Cisco UCS Manager is raising faults. What is the cause of this problem?
What is the correct sequence to export tech support data from the Cisco IMC GUI interface?
You are attempting to install Microsoft Server 2008 R2 on a Fibre Channel LUN, but the installer does not see the LUN. You have used F6 to load the appropriateSCSI driver. What should your first troubleshooting step be?
A customer calls in a trouble ticket and explains that after a power failure, the UPS was discovered to be defective and the Cisco UCS C210 M2 server runningWindows 2008 R2 went down without proper shutdown. After restarting the server, you discover the RAID 5 array rebuilding parity. Which write-cache settings on the LSI MegaRAID 9260-4i controller explain this symptom?
