An engineer must connect a new host to port 1/1 on Leaf 101. A Cisco ACI fabric has an MCP policy configured but experiences excessive Layer 2 loops. The engineer wants the Cisco ACI fabric to detect and prevent Layer 2 loops in the fabric. Which set of actions accomplishes these goals?
An ACI engineer is implementing a Layer 3 Out inside the Cisco ACI fabric that must meet these requirements:• The data center core switch must be connected to one of the leaf switches with a single 1G link.• The routes must be exchanged using a link-state routing protocol that supports hierarchical network design.• The data center core switch interface must be using 802.1Q tagging, and each VLAN will be configured with a dedicated IP address.Which set of steps accomplishes this goals?
An engineer is in the process of discovering a new Cisco ACI fabric consisting of two spines and four leaf switches. The discovery of leaf 1 has just been completed. Which two nodes are expected to be discovered next? (Choose two.)
A bridge domain for an EPG called “Web Servers” must be created in the Cisco APIC. The configuration must meet these requirements:• Only traffic to known MAC addresses must be allowed to reduce noise.• The multicast traffic must be limited to the ports that are participating in multicast routing.• The endpoints within the bridge domain must be kept in the endpoint table for 20 minutes without any updates.Which set of steps configures the bridge domain that satisfies the requirements?
An engineer is troubleshooting fabric discovery in a newly deployed Cisco ACI fabric and analyzes this output:Which ACI fabric address is assigned to interface lo1023?
An engineer is implementing a Cisco ACI data center network that includes Cisco Nexus 2000 Series 10G fabric extenders. Which physical topology is supported?A.B.C.D.
