Create Next App

Exam contains 122 questions

Page 5 of 21

Question 25 🔥

Refer to the exhibit.Which three statements about MPLS LDP operations are true?

Which database solution meets these requirements?

A. The incoming label for 10.2.10.1/32 is 16010 (which is allocated by the local router), and the outgoing label is 22 (as advertised by the next-hop router).

Highly voted

B. The 16003 and 16010 labels are learned from the 192.168.112.40 LDP neighbor.

Highly voted

C. The ImpNull outgoing label for the 192.168.102.0/24 network means that the outgoing label should be removed when sending packets to the 192.168.112.40 next-hop router, when the incoming label is 16003.

Highly voted

D. The ImpNull outgoing label for the 192.168.102.0/24 network means that the local router has not received a label for that network from its neighbor.

Highly voted

E. The Unlabeled outgoing label for 10.10.10.100/32 indicates that a label pop is required when sending packets to the 10.10.10.1 next-hop router.

Highly voted

F. The outgoing label of 22 for 10.2.10.1/32 is learned from the 192.168.112.40 LDP neighbor.

Highly voted

Discussion of the question

Question 26 🔥

On Cisco IOS XR software, how is LDP enabled on an interface?

Which database solution meets these requirements?

A. LDP is automatically enabled globally on all interfaces, when ip cef is enabled globally.

Highly voted

B. LDP is enabled on each interface, using the mpls ip interface configuration command.

Highly voted

C. LDP is enabled on each interface, using the interface command under mpls ldp (MPLS LDP configuration mode).

Highly voted

D. LDP is enabled globally on all interfaces, using the mpls ldp global configuration command.

Highly voted

E. LDP is enabled globally on all interfaces, using the mpls ip global configuration command.

Highly voted

Discussion of the question

Question 27 🔥

Which four statements about REP configurations on a Cisco ME 3400 switch port are true? (Choose four.)

Which database solution meets these requirements?

A. The port must be an NNI type and must be in trunk mode.

Highly voted

B. Use the rep segment number command to enable REP on the switch port.

Highly voted

C. A REP segment cannot be wrapped into a ring topology. REP supports only a topology where each REP segment has two exit points via two edge switches.

Highly voted

D. The port where the segment terminates is called the edge port.

Highly voted

E. With REP, at least one port is always blocked in any given segment-that is, the alternate port.

Highly voted

F. If a failure occurs within the segment, the blocked port goes to the forwarding state after it goes through the listening state and the learning state.

Highly voted

Discussion of the question

Question 28 🔥

A VLAN is a logical grouping of switch ports that belong to which two of these? (Choose two.)

Which database solution meets these requirements?

A. the same virtual switch cluster

Highly voted

B. the same IP subnet

Highly voted

C. the same collision domain

Highly voted

D. the same broadcast domain

Highly voted

E. the same virtual routing and forwarding instance

Highly voted

Discussion of the question

Question 29 🔥

Refer to the exhibit.Which statement is true?

Which database solution meets these requirements?

A. VLAN 1 traffic is sent untagged on the fa0/11 trunk port.

Highly voted

B. All VLANs traffic, including the native VLAN traffic, is tagged with a VLAN ID when it is sent over the fa0/11 trunk port.

Highly voted

C. The switchport trunk allowed vlan command is not configured; therefore, no VLANs are allowed on the trunk.

Highly voted

D. The encapsulation type that is used is 802.1ad.

Highly voted

E. The switchport trunk native vlan command is not configured; therefore, the trunk is not operational.

Highly voted

Discussion of the question

Question 30 🔥

When configuring an ACL entry, which network and wildcard mask matches only IP addresses 10.8.144.0 to 10.8.151.255?

Which database solution meets these requirements?

A. 10.8.144.0 0.0.3.255

Highly voted

B. 10.8.144.0 0.0.7.255

Highly voted

C. 10.8.144.0 0.0.15.255

Highly voted

D. 10.8.144.0 0.0.252.255

Highly voted

E. 10.8.144.0 0.0.248.255

Highly voted

F. 10.8.144.0 0.0.240.255

Highly voted

Discussion of the question

Ready to Pass Your Certification Test

cisco 640_878

Exam contains 122 questions

Lorem ipsum dolor sit amet consectetur. Eget sed turpis aenean sit aenean. Integer at nam ullamcorper a.

Company

Product

Resources

Follow us