A network administrator wants to configure a backup route in case the primary route fails. A dynamic routing protocol is not installed on the router. Which of the following routing features should the administrator choose to accomplish this task?
Which of the following steps of the troubleshooting methodology should a technician take to confirm a theory?
A network administrator is deploying a new switch and wants to make sure that the default priority value was set for a spanning tree. Which of the following values would the network administrator expect to see?
A network administrator is configuring a wireless network with an ESSID. Which of the following is a user benefit of ESSID compared to SSID?
A network administrator needs to connect two routers in a point-to-point configuration and conserve IP space. Which of the following subnets should the administrator use?
SIMULATION -A network technician replaced an access layer switch and needs to reconfigure it to allow the connected devices to connect to the correct networks.INSTRUCTIONS -Click on the appropriate port(s) on Switch 1 and Switch 3 to verify or reconfigure the correct settings:Ensure each device accesses only its correctly associated network.Disable all unused switchports.Require fault-tolerant connections between the switches.Only make necessary changes to complete the above requirements.If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.
