An engineer needs to connect ports 49 and 53 on an MXL to a top of rack (ToR) switch in an LACP port channel. The ToR switch has ports 46 and 60 configured in port channel 100.Which configuration will successfully bring up the port channel on the MXL?
An engineer enters a data center to configure an uplink between an I/O Aggregator (IOA) and an upstream switch. The IOA and upstream switch are configured for spanning tree. The engineer applies the following configuration to the uplink port:✑ interface TenGigabitEthernet 0/12✑ switchport✑ flowcontrol rx on tx off✑ spanning-tree rstp edge-portAs soon as the engineer plugs in the cables, it creates a loop and brings down the network.Which commands should be entered on the IOA to fix loop?
An engineer receives two new I/O Aggregators (IOAs) in default mode. The engineer needs to make sure the uplink ports only pass tagged traffic in VLANs 100 and 200.Which option allows the engineer to accomplish this task?
An engineer needs to configure a full height blade server and iSCSI traffic. The blade has two dual port NDCs. The M1000e chassis only has switches in A fabric.A1 Production traffic:174.1.0.0/16 networkServer facing switch ports use tagged VLANs 10, 30, 50A2 iSCSI traffic:10.0.0.0/24 networkUntagged traffic -Switch is set to access VLAN 20 -The engineer needs to set up the host to operate on the iSCSI network using two ports.Which ports should be used?
Refer to the exhibit.An engineer needs to configure iSCSI boot on a blade.iSCSI boot is NOT working.Which two steps should the engineer take to fix the issue? (Choose two.)
AN engineer needs server 1 in the chassis to be able to communicate on the default untagged VLAN 1 and tagged VLANs 10, 20, and 50. The engineer has port 1 configured with the following settings: interface TenGigabitEthernet 0/1 mtu 12000 switchport vlan tagged 10,20,50 flowcontrol rx on tx offDuring testing, the engineer is unable to communicate with anything on VLAN 1.How should the engineer fix this issue?
