Everything You Need to Pass: dell E20_542

A customer has production and disaster recovery VMAX3 arrays. There is limited bandwidth between the sites. The amount of data which will be replicated by using SRDF to the disaster recovery site is slightly more than the available bandwidth allows.Which action is needed to accommodate the customers need?

A customer is using two VMAX3 arrays with a compression module installed on both arrays. After careful monitoring of the SRDF traffic, they discover that the data is not being compressed.What additional action needs to be performed to enable compression?

You have configured Open Replicator between a new VMAX3 array and a VMAX. A host is connected to the VMAX3 array and a control device is configured to pull data from a remote device on the VMAX. You want the host to be able to access data on the control device while the data is being pulled from the remote device.What will cause writes to the control device to be propagated back to the remote device?

A customer needs to automate SRDF disaster recovery for a Microsoft cluster. Which SRDF solution is recommended?

When data consistency is not a requirement, which SRDF mode is preferred when replicating large volumes of data?

A customer wants to configure a large SRDF deployment between two VMAX3 arrays. The customer has many different applications and workloads. They want to separate each into its own SRDF group.What is the maximum number of SRDF groups this configuration will support?