Everything You Need to Pass: fortinet NSE7

Examine the IPsec configuration shown in the exhibit; then answer the question below.An administrator wants to monitor the VPN by enabling the IKE real time debug using these commands: diagnose vpn ike log-filter src-addr4 10.0.10.1 diagnose debug application ike -1 diagnose debug enableThe VPN is currently up, there is no traffic crossing the tunnel and DPD packets are being interchanged between both IPsec gateways. However, the IKE real time debug does NOT show any output. Why isn't there any output?

Examine the following partial output from two system debug commands; then answer the question below.# diagnose hardware sysinfo memoryMemTotal: 3092728 kBMemFree: 1954204 kBMemShared: 0 kBBuffers: 284 kBCached: 143004 kBSwapCached: 0 kBActive: 34092 kBInactive: 109256 kBHighTotal 1179648 kBHighFree: 853516 kBLowTotal: 1913080 kBLowFree: 1100688 kBSwapTotal: 0 kBSwapFree: 0 kB# diagnose hardware sysinfo shmSHM counter: 285SHM allocated: 6823936SHM total: 623452160concervemode: 0shm last entered: n/asystem last entered: n/aSHM FS total: 639725568SHM FS free: 632614912SHM FS avail: 632614912SHM FS alloc: 7110656Which of the following statements are true regarding the above outputs? (Choose two.)

Which of the following statements are true regarding the SIP session helper and the SIP application layer gateway (ALG)? (Choose three.)

Examine the following partial output from a sniffer command; then answer the question below.# diagnose sniff packet any icmp 4interfaces=[any]filters=[icmp]2.101199 wan2 in 192.168.1.110 -> 4.2.2.2: icmp: echo request2.1011400 wan1 out 172.17.87.16 -> 4.2.2.2: icmp: echo request.....2.123500 wan2 out 4.2.2.2 -> 192.168.1.110: icmp: echo reply244 packets received by filter5 packets dropped by kernelWhat is the meaning of the packets dropped counter at the end of the sniffer?

Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below.# diagnose debug authd fsso list----FSSO logons----IP: 192.168.3.1 User: STUDENT Groups: TRAININGAD/USERS Workstation: INTERNAL2. TRAINING. LABThe IP address 192.168.3.1 is NOT the one used by the workstation INTERNAL2. TRAINING. LAB.What should the administrator check?

A FortiGate device has the following LDAP configuration:config user ldapedit "WindowsLDAP"set server "10.0.1.10"set cnid "cn"set dn "cn=Users, dc=trainingAD, dc=training, dc=lab"set type regularset username "dc=trainingAD, dc=training, dc=lab"set password xxxxxxxnextendThe administrator executed the 'dsquery' command in the Windows LDAP server 10.0.1.10, and got the following output:>dsquery user -samid administrator"CN=Administrator, CN=Users, DC=trainingAD, DC=training, DC=lab"Based on the output, what FortiGate LDAP setting is configured incorrectly?