Ready to Pass Your Certification Test

Ready to guarantee a pass on the certification that will elevate your career? Visit this page to explore our catalog and get the questions and answers you need to ace the test.

fortinet NSE7_SDW_7_2

Custom view settings

Exam contains 70 questions

Page 2 of 12
Question 7 🔥

Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?

Which database solution meets these requirements?
Highly voted
Highly voted
Highly voted
Highly voted
Discussion of the question
Question 8 🔥

What are two common use cases for remote internet access (RIA)? (Choose two.)

Which database solution meets these requirements?
Highly voted
Highly voted
Highly voted
Highly voted
Discussion of the question
Question 9 🔥

Refer to the exhibits.Exhibit A.Exhibit B.An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in exhibit A.After generating GoToMeeting test traffic, the administrator examined the respective traffic log on FortiAnalyzer, which is shown in exhibit B. The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.Which two reasons explain why some log messages show that the traffic matched the implicit SD-WAN rule? (Choose two.)

Which database solution meets these requirements?
Highly voted
Highly voted
Highly voted
Highly voted
Discussion of the question
Question 10 🔥

Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?

Which database solution meets these requirements?
Highly voted
Highly voted
Highly voted
Highly voted
Discussion of the question
Question 11 🔥

Which statement is correct about SD-WAN and ADVPN?

Which database solution meets these requirements?
Highly voted
Highly voted
Highly voted
Highly voted
Discussion of the question
Question 12 🔥

Refer to the exhibit.The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)

Which database solution meets these requirements?
Highly voted
Highly voted
Highly voted
Highly voted
Highly voted
Discussion of the question

Lorem ipsum dolor sit amet consectetur. Eget sed turpis aenean sit aenean. Integer at nam ullamcorper a.

© 2024 Exam Prepare, Inc. All Rights Reserved.