Refer to the exhibit.A network administrator connects several new Aruba Instant APs (at factory defaults), as shown in the exhibit. After waiting several minutes for the cluster to form, the administrator is ready to provision the cluster. The administrator wants to be redirected to the Instant UI without the need to know the correct IP address.How should the administrator connect the management station to enable access to the virtual controller (VC)?
A network administrator wants to see how much power an Aruba AP has dynamically requested from an ArubaOS switch port. Which information should the administrator look at?
A network administrator wants to pre-configure new MSTP region settings on ArubaOS switches, and then apply the new settings at a later time. How can the administrator pre-configure the settings?
A network administrator just received two switches and wants to use the plug-and-play method to establish a Virtual Switching Framework (VSF) fabric with the fewest steps possible.What must the administrator do to establish the fabric in this way?
A network administrator wants to download a configuration from an ArubaOS switch. The administrator does not have local access to the switch and wants to copy the configuration in a secure manner that prevents eavesdroppers from reading the configuration. Which two options can the administrator use to copy the configuration?
Refer to the exhibit.Prior to implementing OSPF on the network, an ArubaOS switch had the IP routing table shown in the exhibit. The network administrator then sets up OSPF in the network. The switch calculates these OSPF routes to 10.1.20.0/24:✑ Through 10.1.0.1 with cost 3 and administrative distance 110✑ Through 10.1.0.2 with cost 3 and administrative distance 110How does the way the switch handles traffic destined to 10.1.20.0/24 change with the introduction of OSPF?
