What is the minimum requirement for a device to pass local MAC authentication (LMA) on an AOS-Switch?
Refer to the exhibit.The network administrator wants to summarize routes as much as possible in between areas. What is the correct range to specify for the router OSPF Area 2 command on Switch-2?
Refer to the exhibit.Switch-2, Switch-5, and Switch-6 currently have many OSPF routes to Area 1 networks. The network administrator wants to replace these routes with a single aggregated route to 10.1.0.0/16 on each switch. Where should the administrator specify the 10.1.0.0/16 range?
Refer to the exhibit.An AOS-Switch has the ACL shown in the exhibit. A network administrator then enters these commands:Switch(config)# mac-access-list standard myACLSwitch(config-std-macl)# deny 007d.45cc.0000 0000.0000.ffffHow does this ACL treat these frames:1 = 007d.45cc.ffff 2 = 007d.45cc.0000
Refer to the exhibits.Exhibit 1 -Exhibit 2 -A network administrator wants to set up mirroring of traffic from port 1 on Switch-1 to port 1 on Switch-2. Exhibit-2 shows the commands that the administrator enters. The mirroring does not work correctly.What must the administrator do to correct the error?
Refer to the exhibit.A network administrator sets up prioritization for an application that runs between Device 1 and Device 2. However, the QoS for the application is not what the administrator expects.How can the administrator check if the network infrastructure prioritizes traffic from Device 1 and Device 2?
