What should an architect use as a guideline to determine when to define another VLAN for wireless devices?
Refer to the exhibit.A customer wants to replace the core and aggregation layer of an existing network. Currently the network routes between the aggregation layer and core, and uses the technologies shown in the exhibit.The customer now wants to route at the core, instead of the aggregation layer, and extend some of the same VLANs in different buildings. However, the customer cannot eliminate the aggregation layer at this point. What should the architect recommend?
A customer requires a wireless upgrade. The architect proposes:✑ Aruba AP-325sMobility Controller (MC) 7210s -✑ Virtual Mobility Masters (MMs)✑ ClearPass✑ AirWaveThe customer is interested in wired authentication, as well as wireless authentication, but does not have the budget to upgrade the wired network. The wired network does not currently support 802.1X or RADIUS.Which feature of the Aruba solution should the architect explain to justify the proposed solution?
An architect plans to purpose two Aruba Mobility Controllers (MCs) in a cluster. The customer has a large building that needs to support about 10,000 devices.The architect plans to associate the Employees WLAN with VLAN ID 10.What is one Aruba best practice for this design?
What is one reason to recommend dedicated Air Monitors (AMs) for a customer, as opposed to APs that are doing WIPS in AP mode (hybrid)?
An architect plans where to deploy new Aruba 320 Series APs at a customer site. The architect plans for the APs to be installed on the ceiling where power is inaccessible. The Ethernet cable run to these locations is CAT6, and the customer wants to support at least 1 GbE connectivity. The architect plans to connect each AP with one Ethernet port to a switch in a nearby wiring closet.Which feature does the switch need to support for this deployment?
