A company has recently purchased a ClearPass AAA solution. Their network consists of AOS-CX switches at the access layer. The company is implementing a rollout of IoT devices for smart building management to control the lighting and HVAC systems. The network administrator is concerned about allowing secure access to these devices since they only support MAC-Auth.Which ClearPass feature should the administrator leverage to help determine that MAC address spoofing is not occurring for this group of devices?
A network administrator sets up two aggregation layer AOS-CX switches in a VSX pair. The switches have layer-2 VSX LAGS to access layer switches. The VSX pair has IGMP configured on the layer-3 VLAN interfaces serving the access layer switches.What is correct regarding how the VSX pair will interact with multicast traffic and messages?
Examine the network exhibit.Examine Route r4's partial OSPF configuration:router ospt 1area 0exitinterface vlan 100ip ospf area 0exitinterface vlan 40ip ospf area 0exitinterface 1/1/1vlan access 100mtu 9000ip ospf heilo-interval 1ip ospf dead-interval 4ip ospf authentication simple-textip ospf authentication-key key 123When executing the "show ip ospf neighbors" command, Router 4 is in a FULL state with Router 3 and Router 2, but a 2-WAY state with Routed.What is causing the 2-WAY state with Router 1?
What would prevent two OSPF routers from forming an adjacency? (Choose two.)
A network administrator is tasked to set up BGP in the company's network. The administrator is defining an eBGP peering between an AOS-CX switch and a directly-connected service provider. The administrator has configured the following on the AOS-CX switch:However, when using the "show bgp all summary" command, the state does not display "Established" for the eBGP peer. What must the administrator configure to fix this issue?
A company has an existing wireless solution involving Aruba APs and Aruba gateway. The solution leverages a third-party AAA solution. The company is replacing existing access switches with AOS-CX 6300 and 6400 switches. The company wants to leverage the same security and firewall policies for both wired and wireless traffic.Which solution should the company implement?
