SIMULATION -There were two systems:✑ system1, main system on which most of the configuration take place✑ system2, some configuration hereConfigure repository.Create a Repository for your virtual machines. The URL is http://station.network.0.example.com/content/rhel7.0/x86_64/dvd
SIMULATION -There were two systems:✑ system1, main system on which most of the configuration take place✑ system2, some configuration hereSSH configuration.✑ Configure SSH access on your virtual hosts as follows.✑ Clients within my22ilt.org should NOT have access to ssh on your systems
SIMULATION -There were two systems:✑ system1, main system on which most of the configuration take place✑ system2, some configuration hereCustomize the User Environment -✑ Create a command called qstat on both serverX and desktop.✑ It should be able to execute the following command (ps ""eo pid, tid, class, rtprio, ni, pri, psr, pcpu, stat, wchan:14, comm).✑ The command should be executable by all users.
SIMULATION -There were two systems:✑ system1, main system on which most of the configuration take place✑ system2, some configuration hereConfigure IPv6 network.✑ Configure eth0 with a static IPv6 addresses as follows✑ Configure a Static IPv6 address in serverX as fddb:fe2a:ab1e::c0a8:64/64✑ Configure a Static IPv6 address in desktopX as fddb:fe2a:ab1e::c0a8:02/64✑ Both machines are able to communicate within the network fddb:fe2a:able/64The changes should be permanent even after the rebootOn ServerX:On DesktopX:
SIMULATION -There were two systems:✑ system1, main system on which most of the configuration take place✑ system2, some configuration hereLink aggregation.✑ Configure your serverX and desktop, which watches for link changes and selects an active port for data transfers.✑ serverX should have the address as 192.169.X.10/255.255.255.0✑ desktopX should have the address as 192.168.X.11/255.255.255.0(Note: where X is your station number)
SIMULATION -There were two systems:✑ system1, main system on which most of the configuration take place✑ system2, some configuration hereSMTP Configuration.✑ Configure the SMTP mail service on serverX and desktopX which relay the mail only from local system through station.network0.example.com, all outgoing mail have their sender domain as example.com. Ensure that mail should not store locally.Verify the mail server is working by sending mail to a natasha user.✑ Check the mail on both serverX and desktopX with the below URL http://station.network0.example.com/system1 http://station.network0.example.com/system2
