200_301 questions • Exam prepare

Exam contains 1395 questions

Page 12 of 233

Question 67 🔥

What is a characteristic of a Layer 2 switch?

Which database solution meets these requirements?

A. responsible for sending data in a particular sequence

B. uses routers to create collision domains

C. avoids MAC address storage for faster transmission

D. uses the data link layer for communications

Highly voted

Discussion of the question

Question 68 🔥

What is a characteristic of private IPv4 addressing?

Which database solution meets these requirements?

A. used on the external interface of a firewall

B. used by ISP's when only one IP is needed to connect to the internet

C. reduces the forwarding table on network routers

D. address space which is isolated from the internet

Highly voted

Discussion of the question

Question 69 🔥

DRAG DROP-Drag and drop the characteristic from the left onto the IPv6 address type on the right.

Question 70 🔥

Refer to the exhibit. Which set of commands must be applied to the two switches to configure an LACP Layer 2 EtherChannel?

Which database solution meets these requirements?

A. SW1(config)#interface range f0/13 -14SW1(config-if-range)#channel-group 1 mode autoSW2(config)#interface range f0/13 -14SW2(config-if-range)#channel-group 1 mode passive

B. SW1(config)#interface range f0/13 -14SW1(config-if-range)#channel-group 1 mode desirableSW2(config)#interface range f0/13 -14SW2(config-if-range)#channel-group 1 mode passive

C. SW1(config)#interface range f0/13 -14SW1(config-if-range)#channel-group 1 mode onSW2(config)#interface range f0/13 -14SW2(config-if-range)#channel-group 1 mode passive

D. SW1(config)#interface range f0/13 -14SW1(config-if-range)#channel-group 1 mode activeSW2(config)#interface range f0/13 -14SW2(config--range)#channel-group 1 mode passive

Highly voted

Discussion of the question

Question 71 🔥

Which fact must the engineer consider when implementing syslog on a new network?

Which database solution meets these requirements?

A. Syslog defines the software or hardware component that triggered the message.

B. There are 16 different logging levels (0-15).

C. The logging level defines the severity of a particular message.

Highly voted

D. By default, all message levels are sent to the syslog server.

Discussion of the question

Question 72 🔥

Which interface is used to send traffic to the destination network?

Which database solution meets these requirements?

A. F0/2

Highly voted

B. F0/20

C. F0/12

D. F0/10

Discussion of the question

Ready to Pass Your Certification Test

cisco 200_301

Exam contains 1395 questions

Lorem ipsum dolor sit amet consectetur. Eget sed turpis aenean sit aenean. Integer at nam ullamcorper a.

Company

Product

Resources

Follow us