What is a characteristic of a Layer 2 switch?
What is a function of a Next-Generation IPS?
Which Windows command is used instead of the route print command to display the contents of the IP routing table?
Refer to the exhibit. How will the device handle a packet destined to IP address 100.100.100.100?
SIMULATION-Guidelines-This is a lab item in which tasks will be performed on virtual devices• Refer to the Tasks tab to view the tasks for this lab item.• Refer to the Topology tab to access the device console(s) and perform the tasks.• Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.• All necessary pre-configurations have been applied.• Do not remove any existing configurations from the devices, only those necessary to make the appropriate changes required to fulfill the listed tasks.• Do not change the enable password or hostname for any device.• Save your configurations to NVRAM before moving to the next item.• Click Next at the bottom of the screen to submit this lab and move to the next question.• When Next is clicked, the lab closes and cannot be reopened.Topology-Tasks-Task 1-Configure trunks between Sw1 and Sw2 on ports E0/0 and E0/1 using the IEEE standard frame tagging method.• Add VLAN 99 as untagged on the trunk ports.• Only extend VLAN 110 and the untagged VLAN across the trunk.• Verify that PC1 is capable of pinging PC2.Task 2-On Sw1 and Sw2, use IEEE 802.3ad link aggregation.• Combine E0/0 and E0/1 into a single logical link while leaving the trunk configurations intact.• Assign number 20 to the link.• Both links must negotiate aggregation.
Refer to the exhibit. A secondary route is required on router R1 to pass traffic to the LAN network on R2 if the primary link fails. Which command must be entered to configure the router?
