What is the impact of entering the qos-mode uniform command on a VTEP interface?
What interface must be selected when configuring the management port from within the MF-CLI environment?
SIMULATION -Configure the system to meet these requirements.Configure R1 with AS 1.R1 must use a static neighbor assignment for BGP peering.R1 needs to redistribute all current and future connected IPv4 routes.All the required BGP configurations have already been completed on R2. R2 resides in BGP AS 2.When you have finished, continue to the next question.
SIMULATION -Use the simulator to perform the following configuration task.Map a single-tagged CVLAN 100 to SVLAN 200 translation on PE switch interface Eth1/1.Map a double-tagged VLAN packet with an outer CVLAN 100 and an inner dot1q 200 to SVLAN 300 translation on PE switch interface Eth1/2.The necessary VLANs and VLAN stacking have already been configured.When you have finished, continue to the next question.
SIMULATION -Create port channel 10 on interfaces Eth 1/11 and 1/12, so that it connects to an already configured switch. A server will be connected on Eth 1/1. Both the server and port channel need VLAN 1 untagged and only VLAN 10 tagged. Complete the configuration on Switch A.When you have finished, continue to the next question.
SIMULATION -VLAN 40 is configured in Switch A with an anycast-address of 192.168.40.254/24. The ARP neighbor suppression is enabled. Use the simulator to create a VTEP named vtep1 and assign an IP address of 10.10.10.1. Map the VNI 400 to VLAN 40.When you have finished, continue to the next question.
